Snap-on Torque Tester, Electronic, 60-600 ft-lb, 3/4" drive

• Designed to be a sturdy, low-cost tester, these electronic torque testers can be placed on the wall in the factory or on a bench to allow operators to test torque wrenches or power tools without having to leave their station

• Integral transducer and sturdy housing allow mounting in virtually any position

• Integral Transducer: Full bridge strain gauge, 350 ohms, 1500 ¬µE, 3mV/V F.S., 3.75V excitation

• Unique neck design allows operator to see display when testing long torque wrenches

• Accuracy: ±0.5% of reading ± 1 count in the least significant digit (10–100% of full range) at 25 ° C

• Display Accuracy: 4 digits, 9,999 counts

• Stability: +0.044% per C

• Track and Peak modes

• Can be used with non-impacting power tools (joint rate simulators required)

• Dual scale (English/Nm or English/dNm)

• Auto/manual display reset

• Reads bi-directional (clockwise and counterclockwise)

• Uses rechargeable NiCad batteries

• All testers include charger (S18005027) and storage case (PB1ETT)